This is one of the most common questions we get asked, and the honest answer is: it depends on what the slab is for, how thick it is, and what’s underneath it — not on a rule of thumb you can apply to every job.

What mesh actually does in a slab

Concrete is strong in compression but weak in tension, and it shrinks slightly as it cures. Reinforcing mesh sits within the slab (typically on spacers, roughly a third to halfway up the depth) and controls the fine cracking that comes from that shrinkage and from any tension in the slab, holding it together as one continuous slab rather than a collection of separate pieces. In a structural application it can also share the load-carrying job with the concrete itself.

When mesh is typically used

  • Driveways and hardstandings that will see vehicle loading
  • Garage and shed bases
  • Patios and paths, particularly larger or unbroken areas
  • Floor slabs in extensions and new structures
  • Any slab your structural engineer or building control has specified reinforcement for

When it might not be needed

A short run of paving, a slab broken into small bays with movement joints, or a very lightly loaded area may be designed without mesh — some specifications rely on joint spacing and slab thickness alone to manage cracking. This is a design decision, not a shortcut: it should be made deliberately by whoever is specifying the slab, not skipped to save cost.

Who actually decides

For anything structural — an extension, a new building, a slab that forms part of a building control application — the decision sits with your structural engineer or is set by building control, and it will be on the drawings. For a straightforward domestic driveway or patio, many contractors specify mesh as standard good practice even without a formal structural design, because the cost of the mesh is small compared to the cost of repairing a cracked slab later.

If you already know you need mesh but aren’t sure which type, see our guide to mesh reference codes, or go straight to our job-specific pages for driveways, floor slabs and patios and paths.

This guide is intended as general background only. The reinforcement your project actually needs — bar size, mesh type, cover, spacing, lap lengths — is set by your structural engineer’s drawings or your building control surveyor, not by a website. Always work to the specification you’ve been given, and if you don’t have one, ask your engineer before you order.

Need reinforcement for your project? Get a fast, competitive quote or call 0207 856 0141 — we deliver rebar and mesh across London and the South East.