Reinforcing mesh (also called fabric) is labelled with a letter and a number — A193, B503, C283 and so on — and once you know how that code is built, you can read any mesh spec sheet in the country.

The letter tells you the pattern

Mesh comes in three main families, each built for a different job:

  • A-series (square mesh) — A142, A193, A252, A393. The wires run the same size and spacing in both directions, giving equal strength both ways. This is the mesh you’ll see most often in domestic slabs, driveways and paths, where the main job is shrinkage-crack control rather than carrying a specific structural load in one direction.
  • B-series (structural mesh) — B196 through B1131. A rectangular pattern with more steel in the main direction than the cross direction, designed for structural slabs where load runs predominantly one way.
  • C-series (long mesh) — C283 through C785. Wider spacing on the cross wires, supplied in long sheets, typically used for paths, pavements and other long, narrow strips.
  • D-series (wrapping mesh) — D49. A lighter, more flexible fabric used for wrapping columns and other curved or awkward applications.

The number tells you the steel area

The number after the letter is the cross-sectional area of steel per metre width, in mm²/m. A193 has 193mm² of steel per metre run in the main direction; A393 has more than double that. Broadly, the higher the number, the heavier the mesh and the more load or crack-control capacity it provides — which is also why A393 costs more per sheet than A142.

Which one do you actually need?

That depends entirely on the application and, for anything structural, your engineer’s specification. A142 or A193 is typical for a domestic driveway or garden slab; A252 or A393 for a heavier-duty domestic or light commercial slab; B-series for structural floor slabs; C-series for paths and pavements. See our guide on rebar vs mesh if you’re not sure whether you need mesh at all.

Where to get exact specs

Every mesh code has its own specification page with exact wire diameters, sheet sizes and weights: browse the full range on our reinforcing mesh page, or jump straight to A142 or A193, our two most popular codes.

This guide is intended as general background only. The reinforcement your project actually needs — bar size, mesh type, cover, spacing, lap lengths — is set by your structural engineer’s drawings or your building control surveyor, not by a website. Always work to the specification you’ve been given, and if you don’t have one, ask your engineer before you order.

Need reinforcement for your project? Get a fast, competitive quote or call 0207 856 0141 — we deliver rebar and mesh across London and the South East.